By Jamie Rivera Published 02/10/2018 17:17:00 | Views: 208
DIY: Trendy Fringe Décor
Fringe is still everywhere and I don’t think it's going out of style anytime soon. Traditionally, you take tiny pieces of fringe and cover shapes and large paper mache objects. For this DIY, I will show you a new technique to breeze through fringing anything.
  • Tissue Paper
  • Cutting Mat and Rotary Cutter
  • Scissors (or fringing scissors – easier)
  • Elmer’s Glue
  • Poster Board
Step One
Lay several sheets of tissue paper flat and fold in half lengthwise. Use your cutting mat, a straight edge and your rotary cutter, to cut strips 2.5” wide across the fold. 

Step Two

Take each set of strips and unfold. Refold lengthwise.

Step Three
Fold in half widthwise and cut fringe on the bottom (not the folded) edge.

Step Four

Separate each fringed strip and refold lengthwise. Take your poster board and across the short edge, run a thin bead of glue across the length. Lay a fringed piece across the glue and press lightly to adhere. If the strip isn’t quite long enough to reach, just add pieces as needed. For the next layer add another bead of glue above the first strip and add another strip.

Step Five

Repeat until the entire poster board is covered. Let dry.

Step Six

Print out letters from your computer. Cut out the letters from the paper. Place each letter on the fringed board, adjusting it so the fringe goes left to right across the letter, and cut loosely around the edge. Once you have the smaller piece, use the template to cut out the shape perfectly.

Step Seven

Repeat with remaining letters. Sometimes after cutting, the tops of the letters are missing fringe. Simply add touch up pieces of tissue paper fringe and glue down. Let dry and trim.

Step Eight

Use a bunting template to make a fun garland. You can use the fringed poster board to make any shapes you like or keep as is for a fun backdrop or to use as a tray liner. The fringing goes quickly using this method and is less tedious than fringing each shape individually.

Step Nine

To make a garland from the letters, simply flip over the pieces and tape down to twine. Here I used washi tape so I can remove and adjust the letters easily after hanging.

photos by
By Jamie Rivera 02/10/2018 17:17:00

Subscribe to comments feed Comments (0)

total: | displaying:

Post your comment. Registration not required

  • Bold
  • Italic
  • Underline
  • Quote

Please enter the code you see in the image: